In the VAC software, setup two Virtual Audio Cables. Think of a virtual audio cable as audio connection done with a cable from one sound card to another, but done completely in software. It’s well worth the $30.00 because it works! There is a trial version available, too. If the 3rd party software needs to interface audio to a radio, you need to use some software that will route audio to and from the RcForb Client. The VCOM emulation also supports what is commonly called “KY CW Keying”. If there is no selection for CAT commands, you can use the RTS signal line for transmit control. When setting up the 3rd party program, set it up to use CAT commands for transmit. The VCOM responds to a basic subset of CAT commands such as frequency, mode and transmit control, which is typically what you need for a logbook or digital program. Some older 3rd party software needs to have its serial port number under 16 or under 8. Although the instructions say to use 38400 for the baud rate, virtual serial ports don’t care about the connection speed. Setup your 3rd party software to connect to a Elecraft K3 on the serial port you just created. Connect to a remote radio to activate the newly created serial port. Select Create Virtual Serial Port, the Serial port you want to create, and check Enable Elecraft K3 emulation. The second method is through Elecraft K3 emulation (VCOM), again found under options. The most common method is the second method, listed below. In this scenario the RcForb Client acts as the main HRD program and you connect the logbook to the Client just like you connect the logbook to the main HRD program via its IP server. Start the HRD program you want, such as the HRD logbook. Start the emulation in the client and connect to a remote. This only applies to the HRD suite of applications, such as their logbook or digital programs. The first method for CAT/CI-V control is with the HRD IP Server Emulation, found under Options->HRD IP Server Emulation. In the Server, the HRD IP server is found in Options->Server Configuration. The client supports VCOM and HRD IP Server emulation. The RcForb Client has two methods of taking care of the CAT/CI-V commands. Most amateur radio software interfaces to a radio through a serial port (CAT/CI-V commands) and/or needs TX/RX audio to and from the radio.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |